How do you start a Toro lawn mower?
How to Start Toro Lawn Mowers
- Press the rubber primer bulb on the side of the mower engine three times. …
- Pull and hold the safety bar near the top of the handle. …
- Grip the handle of the starter rope and pull with a rapid movement. …
- Place the ignition key in the keyhole on the Toro lawn mower.
How do you start a Toro Recycler 21?
Start the mower with the electronic ignition if it has been so equipped as an option. Look on the left side of the handlebar for the switch and key. Grip the handlebar firmly and turn the key until you feel resistance. Hold the key for no more than three to five seconds and release when the engine starts.
Why is my Toro Recycler lawn mower not starting?
The most common reason a Toro mower won’t start is because of a dirty carburetor, other possible reasons include: Fuel Valve Off. Choke Not On. Bad Gas.
How much oil do you put in a brand new Toro lawn mower?
The engine oil capacity should be 0.47 L (16 oz), the oil viscosity should be SAE 30 or SAE 10W-30 detergent oil, and the API service classification should be SJ or higher. Move the machine to a level surface. Remove the dipstick by rotating the cap counterclockwise and pulling it out.
How do you start a Toro lawn mower without primer?
How do you start a lawn mower without primer?
- Find the air cleaner and remove its cover.
- Proceed to remove the air cleaner itself.
- The housing should be clearly exposed by now.
- Quickly put the air cleaner back in its original position and replace the cover.
- Now, your lawn mower is ready to use without the primer bulb!
What causes no spark on lawn mower?
Ignition Module Failure
When it does fail, it is usually due to heat caused from improper wiring of the ground wire to battery voltage. If the engine does not produce spark, other areas of the ignition system should be checked before focusing on the ignition module as source of failure (see above).
Why isn’t my mower starting?
Your Mower Won’t Start:
Other possible causes include: Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas.