Why is the pull cord stuck on the lawn mower?

What does it mean when your lawn mower cord won’t pull?

If you overfill the crankcase with oil or you store the mower in such a way that it’s standing on its front wheels, oil can seep into the piston cylinder and restrict the movement of the piston. When the piston can’t move, the crankshaft can’t turn and you can’t pull the rope.

How do you unstick a lawn mower pull cord?

Sometimes the pull cord crosses over itself when rewinding, and when this happens, it can get stuck. You may be able to free it by pulling it gently to coax it out to its full length, then letting it rewind slowly.

What causes a pull cord to lock up?

One way the starter cord can get stuck is due to hydraulic lock, which is caused by oil getting trapped in the combustion chamber. You’ll need to release the compression and the oil, so remove the spark plug and then give the cord a tug.

Can a seized lawnmower engine be repaired?

Seized Engine



You may be able to free the piston by removing the spark plug and manually rocking the blade. … When you feel the blade starting to turn, spin it a few times slowly in its normal direction of rotation,and then put in the plug and try to start the mower.

IT IS INTERESTING:  How long does a 40 volt lawn mower battery last?

How do I know if my lawn mower engine is seized?

How to tell if a riding lawnmower engine is seized:

  1. It sounds rough.
  2. Hard to start the engine.
  3. The blades are stuck.
  4. The piston and cylinders won’t move.
  5. The oil will be deficient.
  6. The fuel quality will have deteriorated.

Which way do you tip a lawnmower?

According to MarionMowers, It says: If your lawnmower is four stroke (which it is), tip the mower so that the spark plug is pointing skyward, never tip it on its side with the spark plug to the ground.

Can you start a mower without the pull cord?

You can take your pick of electric or battery-powered models, as well as gas mowers with electric starting. … If you do not have enough rope, you will need to replace it with a new one. You can take a wrench and loosen the bolt that holds this in place.

How does a pull start recoil work?

The Pulley System



In the center of the pulley, a recoil spring connects to the pulley through a hook. When the starter rope gets pulled off the pulley and out of the engine, the recoil spring stretches out. When the operator lets go of the rope, the recoil spring snaps back and the rope recoils onto the pulley.

Blog about special equipment