How do you start a Craftsman lawn mower?

Hold onto the recoil starter handle located on the right hand side of the mower and slowly pull the rope. Allow the rope to rewind gently. Pull the recoil rope rapidly using a complete, full-arm motion before letting the rope return gently. Repeat pulling the rope rapidly and returning until the lawn mower starts.

Why does my Craftsman mower won’t start?

Your Mower Won’t Start:



Other possible causes include: Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas.

Can you start a mower without the pull cord?

You can take your pick of electric or battery-powered models, as well as gas mowers with electric starting. … If you do not have enough rope, you will need to replace it with a new one. You can take a wrench and loosen the bolt that holds this in place.

Why is my lawn mower turning over but not starting?

The most common reason for a riding mower cranking over but not starting, is bad gas, but other possible reasons include: Gas Valve Off. No Gas. Choke Fault.

IT IS INTERESTING:  Frequent question: How do you winterize a riding lawn mower?

What can cause a riding mower not to start?

There are many reasons a riding lawn mower won’t start—everything from stale gas to ignition switch problems. If you constantly have to charge the battery, a bad battery or failed alternator could be causing the problem. … Lawn mower ignition switch problems can prevent the starter from getting current.

How do you prime a lawn mower without a primer bulb?

How to Prime a Lawn Mower Without Primer Bulb?

  1. Find the air cleaner and remove its cover.
  2. Proceed to remove the air cleaner itself.
  3. The housing should be clearly exposed by now.
  4. Quickly put the air cleaner back in its original position and replace the cover.
  5. Now, your lawn mower is ready to use without the primer bulb!

Where is the choke on a Craftsman lawn mower?

The choke lever lies on the left of the steering wheel. Turning it on will increase the fuel supply to provide a rich mixture to the engine. Now you can start your mower with ease by turning the ignition key clockwise. After starting the riding Craftsman mower, pull the throttle lever towards the rabbit position.

What oil do I put in my Craftsman lawn mower?

Craftsman lawnmowers use SAE 30 oil, which is the standard small engine oil. This is a type of all-purpose oil that can be used in push mowers and riding mowers. Craftsman mowers can also use synthetic 5W-30 oil because it protects the engine for longer in all temperature conditions.

Can I use car oil for lawnmower?

To make a long story short, yes, you can use car oil to fuel your mower, but it needs to be of high quality. For example, SAE 30 is one of the most commonly used types of high-quality motor oil on the market, and yes, it can be employed for both cars as well as lawn mowers.

IT IS INTERESTING:  What is John Deere load match?

Can I use 10W30 instead of SAE 30 in my lawn mower?

Yes, you can make use 10W30 engine oil instead of the SAE30 in your Lawn Mower. … Again, the SAE30 is better for warmer temperatures while the 10W30 is suitable for varying temperature ranges and also works well in cold weather.

Blog about special equipment