The best way to identify a tractor is by the serial number. Serial numbers on the 9N-2N and 8N tractors are located on the left side of the engine block, just below the head and behind the oil filter.
How can you tell the difference between a Ford 2N and 9N?
The Ford 2N and 9N had similar dimensions, except for the operating weights: the 2N handled 3,070 pounds while the 9N could handle 3,375 pounds. Both tractors had an overall length of 115 inches, a width of 64 inches and a height of 52 inches. Each tractor also had a ground clearance of 13 inches.
How do you decode a Ford tractor serial number?
Serial numbers were stamped on the upper/left/front corner of the engine block until 22238. After that serial numbers were stamped on the left/front/side of the transmission housing.
|Built from 1952 – 1954 Serial Numbers – (Note Change To NAA Prefix)|
|1954||NAA77475 to NAA128965|
How do you tell the year of a tractor serial number?
The 8th digit of the tractor identification number corresponds to the tractor’s model year. To determine the model year, locate the 8th digit of your identification number and compare it to the appropriate table below. The 8th digit of the number is 1.
How do I identify my Ferguson tractor?
Checking the Tractor
Locate the serial number by checking the lower left-hand side and lower right-hand side of the steering wheel panel. In addition, certain older Ferguson tractors have the serial number stamped to a plate mounted to one of these areas of the steering wheel panel.
Which is better 8n or 9n?
This is the main difference between the 8n and 9n Ford tractors; and as you’d expect, the 8n has a number of improvements that make it better than the 9n. One such improvement comes in horsepower. The engines on the 8n tractors are generally a bit more powerful than those on 9n tractors.
What’s the difference between an 8n tractor and a 9n tractor?
They really are basically the same. Only major differences are a couple horsepower, 8n has 4 speed trans and 9n has 3 speed trans. 8n is newer than the 9n and has more hp. Newer 8n have side distributor older 8n’s and 9n’s had front distributor.
Is a Ford 9n a good tractor?
The short answer is yes. The 9N is one awful tractor to work compared to an 8N, NAA or later. Not only do you don’t get position control and live hydraulics like on the 8N, both the clutch and left wheel brake are on the left, meaning with the clutch depressed you can only use the right brake.
Where is the serial number on a Ford 4000 tractor?
The four-cylinder (1962-1965) Ford 4000 series tractors were nearly identical to the 801 and 901 series tractors.
|4000 Serial Numbers|
|Location:||Serial number stamped into the starter mounting flange on the left side of the tractor.|
How many horsepower is a Ford 3600 tractor?
|Ford 3600 Power|
|Engine (gross):||48 hp 35.8 kW|
|Engine (net):||45 hp 33.6 kW|
|Drawbar (claimed):||34 hp 25.4 kW|
|PTO (claimed):||40 hp 29.8 kW|
What horsepower is a Ford 3000 tractor?
|Ford 3000 Power|
|Engine:||47 hp 35.0 kW|
|Gasoline PTO (claimed):||37 hp 27.6 kW|
|Drawbar (tested):||35.43 hp 26.4 kW|
|PTO (tested):||40.63 hp 30.3 kW|