The loss of air flow to the engine caused by too tall or too thick grass or a dirty air filter is often the reason a mower engine stalls. … When you try to mow on overgrown lawn, you end up clogging the air filter and shutting off air to the engine.
Why does my lawn mower only run for a few seconds then dies?
If your lawn mower starts, runs briefly, then dies these are the four most common reasons that’s happening: Dirty carburetor / clogged carburetor bowl. Old gasoline that has gone bad. Dirty or defective spark plugs.
What do you do when your lawn mower keeps shutting off?
Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas. If this doesn’t work, you might need a new fuel filter.
Why does my lawn mower start and then shut off?
The carburetor might be clogged. A clogged carburetor is most commonly caused by leaving fuel in the lawn mower for a long period of time. … This sticky fuel can clog up the carburetor and cause the engine to stall. If the carburetor is clogged, try cleaning it with carburetor cleaner.
Why does my lawn mower start but not stay running?
A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won’t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug. … However, you may need a lawn mower specialist to get you back to trimming your grass.
How do you clean a carburetor on a lawn mower without removing it?
However, you can not spray the carburetor when the engine is off since it cannot do the cleaning without being propelled. All you need to do is to start the engine and spray directly at the center of the carburetor while it is running. Any deposits clogging in the carburetor will easily be removed.
How do you clean a clogged carburetor on a lawn mower?
Step-by-step guide to cleaning lawn mower carburetor
- Safety first. …
- Check to see if the problem really is the carburetor. …
- Remove the outer casing and air filter. …
- Unbolt the carburetor and remove it from the fuel line. …
- Unbolt the bowl and clean the nut. …
- Replace the needle.
How do I know if my lawn mower spark plug is bad?
How to Tell When it Is Time to Change the Spark Plug in a…
- Hard Start. The most common problem associated with a bad spark plug in a lawnmower is that the mower is more difficult than normal to start. …
- Poor Engine Performance. …
- Excessive Fuel Consumption. …
- Physical Appearance.
Will a bad spark plug cause a lawn mower to stall?
Poor Engine Performance
A bad spark plug often causes an engine cylinder to misfire or sound like it’s struggling. The engine might even stall out completely while you are mowing. You may also notice that it becomes increasingly more difficult to restart the mower each time that it dies.
Why does my mower only run when I push the primer?
When you prime the engine you are manually adding extra fuel in, so the running issue is most likely related to poor fuel that will not burn unless there is an excess amount present or a fuel deliver issue preventing enough fuel from getting through to begin with.