Your question: How often should a forklift be checked?

OSHA requires that forklift vehicles have to be inspected at least daily, or after each shift when used around the clock. You will find this requirement in the Powered Industrial Truck standard at 1910.178(q)(7).

What is forklift inspection checklist?

Check tire condition, pressure, and look for any cuts or gouges. Determine fork condition, remembering to check the top clip retaining pin and heel. Ensure load backrest extension functions properly. Check functionality of finger guards. Ensure safety decals and nameplates are legible and match the forklift model.

When should a forklift be checked for damage?

Not only is inspecting your forklift a good way to identify potential problems, but according to the Safe Work Australia Forklift Guide “A pre-start safety check should be completed every time an operator uses a different industrial lift truck and at the beginning of each shift”.

What are 3 fluid levels that need to be checked before using the forklift?

Check of liquid Levels:

  • Hydraulic fluid.
  • Brake fluid.
  • Engine oil coolant.
  • Battery.
  • Fuel.

Which steps must be taken daily before using a forklift?

1) Conducting a visual check



OSHA requires that all forklifts be examined at least daily before they are used to ensure that they’re in safe operating condition. If forklifts are used on a round-the-clock basis, then they must be examined after each shift.

IT IS INTERESTING:  How often do you need a forklift refresher?

What steps should you do every time you park a forklift?

Parking Safety Rules

  • Always try to find a level surface to park on. …
  • Lower forks, or the forklift attachment, all the way to the ground. …
  • Put the gear into neutral.
  • Make sure the wheels are straight. …
  • Set the parking brake every time you park the forklift. …
  • Turn off the engine before dismounting the forklift.

Does OSHA require forklift inspections?

Federal OSHA requires that forklift vehicles have to be inspected at least daily, or after each shift when used around the clock. … OSHA does not require that forklift inspections be documented.

How much back tilt should be applied when picking up a load?

When carrying a load on level ground, the correct position of the forks is 100-150mm (4-6 Inches) off the ground and tilted back sufficiently to stabilise the load.

How fast should you drive a forklift?

1-2011. The Material Handling Equipment Distributors Association (MHEDA) recommends a max speed of 8 mph in general and a 3 mph max speed in areas where pedestrians are present.

Blog about special equipment