You asked: When moving the forklift in reverse you must?

What should you always do before reversing the forklift?

When reversing the forklift, always do so slowly. It’s easy to lose control at speed, especially if the load you’re carrying is very heavy or bulky. Be sure to sound your horn before you reverse to alert pedestrians and other vehicular traffic of your presence.

When should a forklift be driven in reverse?

The driver will slow down and sound the horn at cross aisles and other locations where vision is obstructed. If the load being carried obstructs forward view, the driver will be required to travel in reverse, with the load trailing. 29.

What should you do when changing directions on a forklift?

Look in Direction of Travel — When moving backwards, look backwards. When moving forward, look forward. Know Your Limits — Your visibility is limited when backing, so it’s doubly important to use extreme caution when driving in reverse.

In what situation are you most likely to drive a forklift in reverse?

If the load is too large to see clearly over the top of the load, move the load by driving backwards. Forklift drivers must also drive backwards when going down or up an incline.

IT IS INTERESTING:  Can a lift truck with a 5000 lb capacity at a 24 load center Lift the following load?

What should you never do with a forklift?

Avoid standing or walking under a load, lifting mechanism, or forklift attachment, as loads can fall off on anyone positioned below it. Keep hands and feet clear away from the forklift mast, as a moving mast can cause serious injury.

How much back tilt should be applied when picking up a load?

When carrying a load on level ground, the correct position of the forks is 100-150mm (4-6 Inches) off the ground and tilted back sufficiently to stabilise the load.

How do you move the forks on a forklift?

Raise the fork slightly. The fork will be resting in a small groove in the crossbar; nudge the fork out of the notch so that it will slide along the top of the crossbar. If the forks are rarely adjusted they may be very hard to move. If so, move to the end of the fork and move it from side to side to break it free.

Blog about special equipment