What should you do if the forklift you are driving starts to tip over?

What would cause a forklift to tip over?

Here are examples situations that can cause a forklift to tip over: The center of gravity is on the side of the stability triangle. This might be caused by turning a corner, having an unbalanced load, driving into a pothole, or traveling on a sloping surface. … The forklift quickly accelerating in reverse, or.

Can you jump off a forklift?

Only use a 12-volt negative ground battery to jump start your forklift. … Bring the booster battery as close to the dead forklift as possible so that the jumper cables reach. But make sure the trucks aren’t touching each other.

What is the best way to handle an uneven load?

Tilt the load against the backrest. If the load is unstable, lift the load slightly first, then carefully tilt it back so that the load stays tight against the backrest. If it’s a stable load and secure on the pallet, tilt first, then lift. Once the load is lifted, lower it to a safe traveling height.

Is it easy to tip a forklift?

Turning a corner too quickly can cause the forklift’s center of gravity to shift and can cause the wheel or wheels on one side of the lift to be raised off the ground. When this happens, it’s highly unlikely that the operator will be able to recover and the forklift therefore will therefore tip.

IT IS INTERESTING:  Best answer: How much is a 3 inch lift on a truck?

Can a forklift tip over without a load?

Forklift Safety Rule Two: Don’t tip over. Many untrained operators assume that they can drive faster without a load, but look at the location of the CG with unloaded forks. It is much closer to the sides of the triangle compared with the unloaded location.

When may you lean out of the forklift?

Operators should never lean or reach outside of the cab, as this puts them at risk of contact with passing obstructions/vehicles. Rather than reach out to access something, they should stop their truck in a suitable place, make it safe, dismount and then access it on foot.

Blog about special equipment