What should be done daily before using a forklift?

What must be done daily before using a forklift?

Check for leaks, cracks and visible defects everywhere on the forklift. Check mast chains visually; avoid the use of hands. Test mast chain tension by lifting the load backrest to eye level—the mast chains should be level and any tilting may signify stretching or broken rollers.

What are 3 fluid levels that need to be checked before using the forklift?

Check of liquid Levels:

  • Hydraulic fluid.
  • Brake fluid.
  • Engine oil coolant.
  • Battery.
  • Fuel.

Which steps should you do every time you park a forklift?

Parking Safety Rules

  • Always try to find a level surface to park on. …
  • Lower forks, or the forklift attachment, all the way to the ground. …
  • Put the gear into neutral.
  • Make sure the wheels are straight. …
  • Set the parking brake every time you park the forklift. …
  • Turn off the engine before dismounting the forklift.

What are two guards fitted to a forklift?

It’s vital to keep your whole body within the bounds of the forklift and under the overhead guard. The overhead guard is intended for protection while an operator is within the confines of the seat.

IT IS INTERESTING:  What is a crane on a ship called?

How much back tilt should be applied when picking up a load?

When carrying a load on level ground, the correct position of the forks is 100-150mm (4-6 Inches) off the ground and tilted back sufficiently to stabilise the load.

When picking up a load the forks should be?

Answer Expert Verified. Answer: When picking up a load the correct fork spacing should be 6 inches and also the forks must be spaced as wide apart as necessary for the maximum support of the load.

How do you move the forks on a forklift?

Raise the fork slightly. The fork will be resting in a small groove in the crossbar; nudge the fork out of the notch so that it will slide along the top of the crossbar. If the forks are rarely adjusted they may be very hard to move. If so, move to the end of the fork and move it from side to side to break it free.

Blog about special equipment