What shocks should I get for a lifted truck?

Are shocks different for lifted trucks?

If the truck has a BODY-LIFT, normaly that means it still has or uses the stock length shocks from the factory. … We recommend using a monotube shock design, because a lifted truck tends to have a higher center of gravity, and monotubes offer much better stability, handling, and dampening force.

Do shocks help lift your truck?

Standard shocks without specialized gas will not lift a vehicle. Shocks that use high-pressure nitrogen could provide about half an inch, but this is a side consequence and not the primary objective.

How long do shocks last on lifted truck?

“As a general rule of thumb, OEM hydraulic twin-tube shocks only last about 15,000 to 20,000 miles when used in a work truck environment (towing, hauling heavier loads, off-road/off-pavement use),” says Shane Casad, Bilstein of America, who specializes in pickup suspension setups.

Do I need longer shocks for a 2 inch lift?

If you are adding 2″ of lift in the rear then yes you would need longer shocks or you will be limiting your downtravel by 2″.

Do 2 inch leveling kits require new shocks?

Do I Need New Shocks? Not all leveling kits require new shocks. … However, if your original shocks have 20,000 or more miles on them, you plan to take the vehicle off-road, or if you drive aggressively, you should consider new shocks mandatory with the installation of a suspension leveling kit.

IT IS INTERESTING:  How does Pascal's principle relate to hydraulic lifts?

Do I need longer shocks for a 3 inch lift?

Suspension lift kits that raise your truck higher than 3 inches will usually require a new shock absorber to take up the difference in distance between the top and bottom mounting points of the shock. To simplify the shopping experience, the majority of brands we carry will include new shock absorbers in these cases.

Do you need new shocks with a 2.5 inch lift?

Next up is a 2” or 2.5” lift, typically consisting of spacer and add-a-leaf kits. At this point, you’ll also usually need new shock absorbers with longer tubes. … At this point, a steering damper might also be necessary to correct a tendency toward wander and bump steer.

What is the cheapest way to lift a truck?

Cheap Way to Lift a Truck

  • Add aftermarket torsion keys. They can add up to 1.5 inches to your ride height while maintaining the factory settings. …
  • Purchase a leveling kit. …
  • Give your truck a body lift. …
  • Install a a “premium lift system,” which combines a body lift and a leveling kit.

How do I know if my truck shocks are bad?

Other signs of car shocks and struts in bad condition are unusual noises over bumps, excessive body lean or sway in turns, or that the front end of the vehicle dives sharply in hard braking. Bad shocks also can affect steering control and cause uneven tire wear.

Should I replace all 4 shocks at the same time?

Finally, replace your struts and shocks in pairs



Shocks and struts should always be replaced in pairs or, better yet, all four, for even, predictable handling and control. After all, all four have been on the vehicle for the same number of miles and worked under the same conditions.

IT IS INTERESTING:  Your question: How much does it cost to get a forklift license in Ontario?
Blog about special equipment