What is the proper position of the forks when the forklift is left unattended?

Lower the forks to the floor when parking the forklift. Make sure that the forks touch the ground when you are leaving. Apply the parking brake when it is the idle position. All operational controls of the truck must be in the neutral position before the driver alight the forklift compartment.

What precautions should you take prior to leaving a forklift unattended?

Never leave a forklift unattended without lowering the forks, setting the brake, neutralizing controls, shutting off power, and removing the ignition key.

How low should the forks generally be when Travelling without a load?

Travel with forks as low as possible from the floor and tilted back (usually within 10-15 cm (4 to 6 inches) above the floor).

What must happen when a powered industrial truck is left unattended?

When a powered industrial truck is left unattended, load- engaging means shall be fully lowered, controls neutralized and brakes set. Unless the truck is in view and within 25 feet (7.62 m) of the operator, power shall be shut off. Wheels shall be blocked or curbed if the truck is on an incline.

IT IS INTERESTING:  How wide is a skid loader bucket?

How do you move the forks on a forklift?

Raise the fork slightly. The fork will be resting in a small groove in the crossbar; nudge the fork out of the notch so that it will slide along the top of the crossbar. If the forks are rarely adjusted they may be very hard to move. If so, move to the end of the fork and move it from side to side to break it free.

What are 3 fluid levels that need to be checked before using the forklift?

Check of liquid Levels:

  • Hydraulic fluid.
  • Brake fluid.
  • Engine oil coolant.
  • Battery.
  • Fuel.

How much back tilt should be applied when picking up a load?

When carrying a load on level ground, the correct position of the forks is 100-150mm (4-6 Inches) off the ground and tilted back sufficiently to stabilise the load.

When parking or leaving the forklift you must remove the ignition key?

When parking a forklift, slowly bring the vehicle to a stop, set the parking brake, turn off the ignition and remove the keys. If you are parking on an incline, turn the front wheels away from the downgrade so the forklift will not slide.

What steps should you do every time you park a forklift?

Parking Safety Rules

  • Always try to find a level surface to park on. …
  • Lower forks, or the forklift attachment, all the way to the ground. …
  • Put the gear into neutral.
  • Make sure the wheels are straight. …
  • Set the parking brake every time you park the forklift. …
  • Turn off the engine before dismounting the forklift.
IT IS INTERESTING:  Are let variables hoisted?

When traveling with a load your forks should be no more than 6 inches off the floor?

Keep the forks 6 to 10 inches above the ground to avoid potential hazards on the ground. Remember that forklifts are top-heavy. Carry the load low and tilted back. Use caution when carrying a load on an uneven surface; it creates a tip-over hazard.

Blog about special equipment