What are the 3 pedals on a forklift for?

There are three types of forklift pedals: accelerator, brake, and clutch. A typical forklift has all three pedals present, but there are exceptions. For instance, some forklifts have an inching pedal that is used to disengage the lift’s transmission and slow down the machine or bring it to a complete stop.

What does inching pedal mean?

An inch pedal or inching pedal is a pedal used in many models of mobile machinery with a hydraulic pilot pressure output proportional to the pedal position, or an electronic pedal with a proportional electric signal output.

How do you use a clutch on a forklift?

Push in the clutch if it is a manual transmission, and put the transmission in “Forward.” Push down on the gas pedal and the forklift will move forward in drive. Steer with the steering wheel the way you would a car, except be mindful that it is the rear wheels that turn and not the front wheels (see below).

Why do forklifts have two brake pedals?

To begin with, every forklift comes equipped with an accelerator and a brake pedal. … That third pedal is called an Inching Brake. Its function is twofold. It initially acts as a brake and secondly disengages the transmission, allowing the engine speed to increase or decrease without affecting the drive of the forklift.

IT IS INTERESTING:  Best answer: What is the Hills Hoist made out of?

How do I get my forklift to go forward?

Turn the key to start the forklift.



Locate the emergency brake lever on the left side of the machine and make sure it’s pulled down and activated. Put the key into the ignition on the right side of the steering column and turn it forward to start the forklift’s engine.

Do all forklifts have a clutch?

Do all forklifts have a clutch? Some forklifts also have a clutch, which allows shifting into higher forward gears. The inching pedal gives the operator more control of the forklift in tight places. … Forklifts are equipped with a parking brake.

When you stop a forklift by plugging you should?

8 When you stop the forklift by “plugging”, you should: b. Move the control handle through neutral to the opposite direction to slow the forklift, then release the deadman pedal to stop.

Blog about special equipment