In what situation are you most likely to need to drive a forklift in reverse?

If the load is too large to see clearly over the top of the load, move the load by driving backwards. Forklift drivers must also drive backwards when going down or up an incline.

In what circumstances should you drive in reverse on an incline forklift?

When going down a ramp, drive in reverse with the load and keep the forks pointed up the slope. When traveling without a load, the forks should always point down the slope. The forklift operator should also drive in reverse up the ramp or drive forward when going down the ramp.

What should you do prior to reversing a forklift?

Forklift operators should always:

Look over both shoulders before reversing. Get on and off the forklift using 3 points of contact. Leave the forklift parked with the forks’ tips on the ground. Carry loads with the forks tilted back.

What are the three most common reasons for forklift accidents?

According to OSHA, 70 percent of workplace accidents can be avoided with proper training and safety procedures. NIOSH states that the three most common types of injuries occur when: A forklift overturns; workers are struck, crushed, or pinned by a forklift; and workers fall from a forklift.

IT IS INTERESTING:  Who hoisted the first national flag after independence?

Are you supposed to drive a forklift in reverse?

The driver will slow down and sound the horn at cross aisles and other locations where vision is obstructed. If the load being carried obstructs forward view, the driver will be required to travel in reverse, with the load trailing.

When parking or leaving the forklift you must remove the ignition key?

When parking a forklift, slowly bring the vehicle to a stop, set the parking brake, turn off the ignition and remove the keys. If you are parking on an incline, turn the front wheels away from the downgrade so the forklift will not slide.

How much back tilt should be applied when picking up a load?

When carrying a load on level ground, the correct position of the forks is 100-150mm (4-6 Inches) off the ground and tilted back sufficiently to stabilise the load.

What steps should you do every time you park a forklift?

Parking Safety Rules

  • Always try to find a level surface to park on. …
  • Lower forks, or the forklift attachment, all the way to the ground. …
  • Put the gear into neutral.
  • Make sure the wheels are straight. …
  • Set the parking brake every time you park the forklift. …
  • Turn off the engine before dismounting the forklift.

What are 3 fluid levels that need to be checked before using the forklift?

Check of liquid Levels:

  • Hydraulic fluid.
  • Brake fluid.
  • Engine oil coolant.
  • Battery.
  • Fuel.
Blog about special equipment