How do you oil a Hills Hoist?

To LUBRICATE your Hoist’s worm gear and handle assembly: a) Wind hoist to full height and apply approx. 1 teaspoon of oil through hole in elevating shaft. b) Apply a few drops of oil through oil hole in gear case above handle shaft. USE ANY LIGHT GRADE OIL.

How do you remove a stuck Hills Hoist?

Wrap a chain or rope around the base, and then around a 2″ x 4″ length of lumber (or somesuch) near the end. Put one end of the board on the ground, and lift the other end. Use it as a lever to pull straight up and remove it.

How do I get rid of daytek clothesline?

Press the dual latches inward and slide downwards until all 4 arms are in a vertical position and are secured in the slots located in the top cap. 3. Lift the support ring from the ground socket and lift out the clothesline.

How do you remove old washing lines?

Dig around the cement base with a shovel. If your pole doesn’t have a cement base, dig around the pole until you’re able to lean against the pole, working it loose. You can then remove the pole.

Why won’t my rotary washing line open?

The weather has brightened so out comes your trusty Rotary Washing Line – but it won’t open! … Rotary Airers can get tangled when they are stored away or collapsed hastily in bad weather. Most commonly, it’s because the clothes lines have got looped over one or more of the arms.

IT IS INTERESTING:  You asked: Who hoists the flag on Republic Day in states?

How do you fix the hills clothesline?

Here are two ideas that will reset the mechanism inside the clothesline: If the head is at its lowest point, you may try rotating the handle clockwise and push the head up at the same time. If the head is at its highest point you may try to rotate the handle anti-clockwise and pull the head down at the same time.

Can you restring a rotary clothesline?

Tie one line end to the most inside hole on one arm (position 0), then put through to 1, 2,3,4 and go on to 41. When line goes through hole 41, 42, 43 and 44, line need to go round twice and then to the last hole 45 and tie off.

How do I change the cord on my daytek clothesline?

To replace a line on your Daytek Rotary Clothesline, you must remove the Tensioner Block Tops of the effected line. To remove the Tensioner Block Tops, a) Place your index finger on top of the Tensioner Block and over the Nut to ensure that the Nut is held in position.

Blog about special equipment