How do you check a forklift?

What should I check before operating a forklift?

Forklift Pre-Operation Checklist

  • Fluid levels — oil, water, and hydraulic fluid.
  • Leaks, cracks or any other visible defect including hydraulic hoses and mast chains. …
  • Tire condition and pressure including cuts and gouges.
  • Condition of the forks, including the top clip retaining pin and heel.
  • Load backrest extension.

When should a forklift be checked for damage?

Not only is inspecting your forklift a good way to identify potential problems, but according to the Safe Work Australia Forklift Guide “A pre-start safety check should be completed every time an operator uses a different industrial lift truck and at the beginning of each shift”.

What are the three safety inspection steps you must take before operating a forklift?

A proper forklift inspection involves conducting a visual check, an operating inspection, and documenting all inspections (preferably through safety inspection software).

How often should operators inspect forklift?

Federal OSHA requires that forklift vehicles have to be inspected at least daily, or after each shift when used around the clock. You will find this requirement in the Powered Industrial Truck standard at 1910.178(q)(7).

IT IS INTERESTING:  Can you hoist with one carer?

What are 3 fluid levels that need to be checked before using the forklift?

Check of liquid Levels:

  • Hydraulic fluid.
  • Brake fluid.
  • Engine oil coolant.
  • Battery.
  • Fuel.

What is the first thing you do before operating a forklift?

The first step toward safe forklift operation is conducting the preoperational inspection. Forklift operators should conduct the inspection at the start of each work shift to ensure that the forklift will work properly. According to OSHA, 1 in 15 forklift-related accidents are caused by improper maintenance.

What steps are done daily before using a forklift?

Walk Around Inspection

  • Tires: Ensure the forklift’s tires are in good condition. …
  • Hoses, Belts & Chains: Inspect these for excessive wear. …
  • Fluid Levels: Check hydraulic fluid levels and ensure there are no leaks.
  • Engine / Power Source: Check engine in IC forklifts and check the power source in electric forklifts.

What should you do every time you park a forklift?

Parking Safety Rules

  • Always try to find a level surface to park on. …
  • Lower forks, or the forklift attachment, all the way to the ground. …
  • Put the gear into neutral.
  • Make sure the wheels are straight. …
  • Set the parking brake every time you park the forklift. …
  • Turn off the engine before dismounting the forklift.

How much back tilt should be applied when picking up a load?

When carrying a load on level ground, the correct position of the forks is 100-150mm (4-6 Inches) off the ground and tilted back sufficiently to stabilise the load.

What is the area of risk when operating a forklift?

5. Floor Conditions. The surrounding work area presents several potential forklift dangers. Debris, puddles, unstable ground and other floor obstructions can cause falls or overturns if not immediately taken into account.

IT IS INTERESTING:  Your question: How long is a forklift propane tank good for?
Blog about special equipment