How do you assemble Hills Hoist?

How do you remove a Hills hoist from the ground?

Wrap a chain or rope around the base, and then around a 2″ x 4″ length of lumber (or somesuch) near the end. Put one end of the board on the ground, and lift the other end. Use it as a lever to pull straight up and remove it.

How do you fix the hills clothesline?

Here are two ideas that will reset the mechanism inside the clothesline: If the head is at its lowest point, you may try rotating the handle clockwise and push the head up at the same time. If the head is at its highest point you may try to rotate the handle anti-clockwise and pull the head down at the same time.

How do you remove old washing lines?

Dig around the cement base with a shovel. If your pole doesn’t have a cement base, dig around the pole until you’re able to lean against the pole, working it loose. You can then remove the pole.

How do you lubricate Hills Hoist?

To LUBRICATE your Hoist’s worm gear and handle assembly: a) Wind hoist to full height and apply approx. 1 teaspoon of oil through hole in elevating shaft. b) Apply a few drops of oil through oil hole in gear case above handle shaft. USE ANY LIGHT GRADE OIL.

IT IS INTERESTING:  How long is a mass hoisting license good for?

What kind of pulley is used on a clothesline?

With a fixed pulley, you attach a pulley to a hook or a wall. The pulley doesn’t move. That’s like the clothesline pulley in the picture here. A fixed pulley doesn’t give you any mechanical advantage, but it changes the direction of the force.

How do I tighten my daytek clothesline?

Loosen the bolt from under the arm of the clothesline. 3. Pull the line through the Tensioner Block to required tension and re-tighten the bolt.

Blog about special equipment